#Nvidia custom resolution not showing install#
#Nvidia custom resolution not showing drivers#

I have tried editing nf and nf but changes are ignored or dont apply? Is the load order for display drivers and kernel wrong? I have already spent days and days reading about dual gpu nvidia issues. This feels like an xserver, xorg or nvidia configuration issue and I am too new to desktop linux to have the fundamental knowledge to isolate further. You have to use the mouse to scroll the display to see the entire rendered resolution.Д«) black screen on all monitors but you can see the cursor on the 1070 display, 1050 monitor goes to sleep.Д¬) black screen and all monitors go into sleep mode / no source detected.Д¬hanging DVI / HDMI ports do nothing, nor changing cables. If you enable a display (any make model) on the 1050, the resolution either:ДЄ) gets added onto the 1070 monitor as if it were an ultra widescreen.

Switching to proprietary drivers causes the 1050ti to no longer allow displays. I cannot swap the 1050ti to pcie02 because the 10 then share an IOMMU group and I donвЂ™t want to run a custom patched kernel to isolate them (causes a new set of issues doing so). 4x does not bottleneck the 1050 (its just for video acceleration across multi monitors anyway)

I cannot swap the 1050ti to pcie01 or 02 and put the 1070 in pcie03 because the slot is only 4x and would kill the cards performance. Switching the 1050 to any pcie slot by itself (no 1070 installed) works as normal Removing the 1070 from the pc will allow the 1050 to work as normal Worked but only 1 monitor sucks for host OS.Д«oth GPUs work using Windows 10 LTSC as a host OSД«oth GPUs work using at least the following distros - ubuntu, mint, zorin OS as host OS.Д«oth GPUs work on manjaro, endeavor but only when using the nvidia open source drivers (causes screen tearing and other issues but does work on all gpu and monitors).

#Nvidia custom resolution not showing install#

Previous install had a windows vm with the 1070ti passed through and intel integrated for the host OS. Previous version was kernel 5.10 and kde 21.07. OS - Manjaro KDE 21.1 - FRESH INSTALL as of this post This card will be dual monitor for host OS.PCIE-03 x4 - nvidia 1050ti - 04:00 2 monitor attached This card will be passed to a guest windows VM.PCIE-01 x16 - nvidia 1070ti - 01:00 1 monitor attached I have narrowed it down to something wrong in either the way ARCH, the kernel, (grub too?) handle the proprietary nvidia drivers, or the proprietary nvidia drivers / their configuration. Preface: I am new-ish to linux as my daily driver OS but not to troubleshooting.